Aspire Nautilus All-In-One Pod System
Introducing the Nautilus AIO (All In One)! This pod vape boast a huge tank for such a small device while still packing in a battery that will give you plenty of time between charges. On top of everything else, you have the famous Nautilus coil platform at the heart of this pod vape!
The Nautilus AIO pods are reusable, which means that you just replace the coil that goes into the pod instead of replacing the whole pod. They do sell replacement pods if you break or lose one, or if you simply want to run two different flavors throughout the day without sacrificing flavor quality or clarity.
The Nautilus AIO is capable of using the 1.6 ohm, 1.8 ohm, and 1.8 ohm NS (Nicotine Salt) coils. The 0.7 and 0.4 ohm coils are not compatible due to the programming of the battery not allowing the device to fire resistances that low. The pod itself simply clicks into place by pushing the pod straight down onto the battery. To remove the pod, push both of the release buttons on either side of the battery. The pod has an AFC (Air Flow Control) ring on the bottom that is connected to a cap that can be removed so that you can change your coil out. There is also a bright orange plug that seals your fill hole, which can be easily pulled out and pushed back in for filling.
The battery boasts a 1000mAh battery and fires at a continuous 12 watts, which means that you will get a much more consistent vaping experience throughout the entire charge of the battery in comparison to most other pod vapes that use a more common “Bypass” method. Pods that use the bypass method will only provide power based on the remaining voltage in the battery from 4.2 Volts to 3.3 Volts, so they will feel weaker and weaker as the battery drains until you charge them again.
The Nautilus AIO uses a button to fire the device that illuminates when you push it to display your remaining battery life. The combination of blue and orange (what looks like purple to some of us at the shop) signifies that the remaining battery life is between 100-70%, a blue light means 70-30% of battery life remains, and an orange light signifies 30% or less. The battery charges through a micro USB located on the side of the device. When the device it is plugged in, it will light up blue and orange. Once the device is fully charged, it will flash 20 times and the led light will shut off.
The Aspire Nautilus AIO Pod System Includes:
- 1 Nautilus AIO Device
- 2 1.8ohm BVC Coils
- 2 Extra O-Rings
- 1 Silicone Seal
- 1 MicroUSB Cable
- 1 Warranty Card
- 1 User Manual
Aspire Nautilus All-In-One Pod System Review:
With the Nautilus AIO, Aspire has improved upon everything that made the Breeze 2 such a good device and upped the ante even further.
The Nautilus AIO utilizes the same regular Nautilus coils that everyone has known and loved for years, giving us a sort of hybrid of the Nautilus tank, a pod system, and an AIO device. Instead of swapping pods every time, you just swap out the coils, which reduces plastic waste and provides your wallet some relief, seeing as the coils are cheaper than most pods are.
This device packs a pretty sizable 1000 mAh battery which will provide you with almost an entire day's worth of vaping without needing to charge, while maintaining a compact size that easily allows you to slip it into your pocket or handbag. Along with the large battery, it also has a juice capacity bigger than most other pod systems, boasting a 4.5ml juice capacity. All of this is packed into a device that is only 87.5mm tall and 37.5mm wide.
All in all, this is one of the best AIO devices on the market. Get the battery life and juice capacity of a larger device packed into a small and easy to carry frame, along with the usual great taste and reliability that Aspire has been known for.
How To Prime Your Aspire Nautilus Coil:
- To prime your coil, take a tissue and block off the airflow holes on the very bottom of the coil by pinching the tissue with your fingers over the air flow holes
- Slowly squeeze juice into the top of the coil until it is a millimeter or two above the top of the wicking material
- Wait until the juice inlets on the outside of the coil darken with juice, then wrap the entire coil in a tissue and shake the excess juice out of the coil
- Once the coil is primed and cleared of excess juice, screw it into the airflow control ring
- Screw the assembled coil and AFC into the pod
- Remember to set your airflow however you like
- Now you're ready to fill!
How To Fill Your Nautilus AIO Pod:
- To fill your pod, first remove the pod from the device by pushing the buttons on the side of the device and pulling up on the pod
- Turn the pod upside-down and remove the orange plug from the fill hole
- Take the nipple of your vape juice bottle and slowly fill down the side of the fill hole taking care to allow for air to escape as you fill the pod
- Keep in mind that this is a 4.5ml pod, so it takes a lot of juice
- Once your pod is full, replace the orange plug in the fill hole click the pod into place on your device
- Now you're ready to vape!
How to Activate the Aspire Nautilus AIO Battery.
- Safety switch prevents the battery from activating.
- Rapidly press the switch 5 times in under one second to activate.
- Then press and hold the switch to vape.
- Rapidly press 5 more times to de-activate.
Rechargeable Battery Warning. Use At Your Own Risk!
NOTE: There is an inherent risk with the use of any and all rechargeable batteries in any circumstance. Vaporleaf Inc. is are not responsible for damage if there is any modification of the batteries/chargers in any form or shape (including pack making).
Vaporleaf Inc. is not responsible for any damage caused by the misuse and/or mishandling of Li-ion (Lithium-ion), LiPo (Lithium-ion Polymer) and any rechargeable batteries and chargers.
Use special caution when working with Li-ion (Lithium-ion), LiPo (Lithium-ion Polymer) and any rechargeable cells, as they are very sensitive to charging characteristics and may explode or burn if mishandled. Make sure the user has enough knowledge of Li-Ion (Lithium-ion), LiPo (Lithium-ion Polymer) and any rechargeable cells in charging, discharging, assembly and storage before use.
Always charge in/on a fire-proof surface. Never leave charging batteries unattended. Do not use any rechargeable battery as well as any battery charger if any visible damage is present, as well as if the cell or charger has been stressed through mishandling, accidental or otherwise, even if damage may not be visible.
Always store and transport rechargeable cells in a safe, non-conductive container in a controlled environment. Dispose of all battery cells and chargers in accordance to local laws and mandates.
Vaporleaf Inc. will not be held responsible or liable for any injury, damage, or defect, permanent or temporary that may be caused by the improper use of a Li-ion (Lithium-ion), LiPo (Lithium-ion Polymer) and any rechargeable battery/batteries. Please have a basic understanding of the batteries you are using and how to care for them properly.
How To Prime And Fill Your Aspire Nautilus AIO: